smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-2-amd64] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Toshiba 2.5" HDD MQ01ABF... Device Model: TOSHIBA MQ01ABF050 Serial Number: X6I6SAUVS LU WWN Device Id: 5 000039 7558860a3 Firmware Version: AM0P2D User Capacity: 500 107 862 016 bytes [500 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 3.0, 6.0 Gb/s (current: 1.5 Gb/s) Local Time is: Tue Dec 21 12:19:25 2021 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 119) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 128 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0 3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 1348 5 Reallocated_Sector_Ct 0x0033 100 100 050 Pre-fail Always - 0 9 Power_On_Hours 0x0032 090 090 000 Old_age Always - 4359 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 2261 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 23 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 268 193 Load_Cycle_Count 0x0032 097 097 000 Old_age Always - 35905 194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 37 (Min/Max 11/50) 199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0 240 Head_Flying_Hours 0x0032 090 090 000 Old_age Always - 4202 241 Total_LBAs_Written 0x0032 100 100 000 Old_age Always - 8635546479 242 Total_LBAs_Read 0x0032 100 100 000 Old_age Always - 11477597224 254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 2 SMART Error Log Version: 1 ATA Error Count: 2 CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 2 occurred at disk power-on lifetime: 2577 hours (107 days + 9 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 50 bf 1a 9a 40 Error: ICRC, ABRT at LBA = 0x009a1abf = 10099391 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 40 50 80 15 9a 40 00 00:36:43.881 WRITE FPDMA QUEUED 61 40 48 40 10 9a 40 00 00:36:43.870 WRITE FPDMA QUEUED 61 40 38 00 0b 9a 40 00 00:36:43.860 WRITE FPDMA QUEUED 61 40 30 c0 05 9a 40 00 00:36:43.852 WRITE FPDMA QUEUED 61 40 28 80 00 9a 40 00 00:36:43.841 WRITE FPDMA QUEUED Error 1 occurred at disk power-on lifetime: 2576 hours (107 days + 8 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 84 41 f8 ff d7 a8 40 Error: ICRC, ABRT at LBA = 0x00a8d7ff = 11065343 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 61 40 f8 c0 d2 a8 40 00 00:30:33.516 WRITE FPDMA QUEUED 61 40 08 80 cd a8 40 00 00:30:33.511 WRITE FPDMA QUEUED 61 40 00 40 c8 a8 40 00 00:30:33.504 WRITE FPDMA QUEUED 61 40 f0 00 c3 a8 40 00 00:30:33.498 WRITE FPDMA QUEUED 61 40 b8 c0 bd a8 40 00 00:30:33.491 WRITE FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 4359 - # 2 Short offline Completed without error 00% 4354 - # 3 Short offline Completed without error 00% 1307 - # 4 Short offline Completed without error 00% 0 - # 5 Short offline Aborted by host 90% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.